1582211 vs 62PC8FS
| Part Number |
|
|
| Category | Circular Connectors | Circular Connectors |
| Manufacturer | Phoenix Contact | Switchcraft Inc. |
| Description | CONN INLINE BLACK,3+PE-PO | CPMM RCPT 8CONT DIN R/A PCB SHLD |
| Package | - | - |
| Series | QPD | - |
| Mounting Type | Free Hanging (In-Line) | Through Hole, Right Angle |
| Termination | IDC | Solder |
| Ingress Protection | IP68/69K - Dust Tight, Water Resistant, Waterproof | - |
| Current Rating | 20A | 3A |
| Voltage - Rated | 630V | 34VDC |
| Contact Finish | Silver | Tin |
| Orientation | Keyed | N (Normal) |
| Number of Positions | 4 (3 + PE) | 8 |
| Connector Type | Distributor | Receptacle, Female Sockets |
| Fastening Type | Threaded | Push-Pull |
| Shell Material, Finish | Polyamide (PA), Nylon | Zinc Die Cast, Nickel Plated |
| Features | - | Shielded |
| Shell Size - Insert | - | DIN (270 Degree) |
-
1. How to get pins out of circular connector
Use professional tools: For some connectors, professional tools may be required to safely remove pins. For example, the small two-petal needle remover mentioned may not be very easy to use, but if there is no other better method, you can try to use it. If the connector is damaged or the repair cost is too high, consider replacing a new connector.
-
2. How to solder a circular connector
1. Remove the insulator, prepare the soldering iron and needle-nosed pliers or tweezers;
2. Place the blade of the soldering iron tip close to the solder joint, and keep the soldering iron at an angle of about 60° to the horizontal plane so that the molten tin can flow smoothly from the soldering iron tip to the solder joint. The time the soldering iron tip stays at the solder joint should be controlled to 1-2 seconds;
3. Make sure that the insulator is not burned, the tin on the solder joint is smooth, burr-free, and there is no cold solder joint, and the definition of the solder wire meets the requirements of the drawing. -
3. How to wire a circular connector
1. Insert the wire into the pin hole inside the connector to ensure that the metal conductor is in full contact with the pin.
2. Use wire twisters to tighten the screws or clips on the connector to ensure good and firm contact between the connector and the wire.
3. Check if there is any exposed metal surface on the connector. If necessary, re-strip it.
4. Wrap the connected wires with electrical tape to prevent loosening or short circuit problems. -
4. What are the materials of circular connectors?
1. Metal: It has good mechanical properties and conductivity, and is used for contacts and housings.
2. Plastic: Lightweight, good insulation, and able to resist corrosion by some chemicals, used for insulators and housings.
3. Rubber: Has good elasticity and corrosion resistance, used for waterproofing and sealing.
