41-00004 vs 8P1P006210GRF01
| Part Number |
|
|
| Category | Circular Connectors | Circular Connectors |
| Manufacturer | Conec | NorComp Inc. |
| Description | CONN RCPT 3POS CABLE PIN 7/8" | CONN RCPT FMALE 6POS GOLD SOLDER |
| Package | - | - |
| Series | 41 | QUIK-LOQ? 8P1P |
| Mounting Type | Free Hanging (In-Line) | Panel Mount, Bulkhead; Through Hole |
| Termination | Screw | Solder |
| Ingress Protection | IP67 - Dust Tight, Waterproof | IP50 - Dust Protected |
| Current Rating | 12A | 6A |
| Voltage - Rated | 250V | 450V |
| Contact Finish | Gold | Gold |
| Orientation | Keyed | Keyed |
| Number of Positions | 3 (2 + PE) | 6 |
| Connector Type | Receptacle, Male Pins | Receptacle, Female Sockets |
| Shell Size - Insert | 7/8"-3 | - |
| Fastening Type | Threaded | Push-Pull |
| Shell Material, Finish | Polyamide (PA6), Nylon 6, Glass Filled | Polyacrylonitrile Butadiene Styrene (ABS), Polycarbonate (PC) |
-
1. How to get pins out of circular connector
Use professional tools: For some connectors, professional tools may be required to safely remove pins. For example, the small two-petal needle remover mentioned may not be very easy to use, but if there is no other better method, you can try to use it. If the connector is damaged or the repair cost is too high, consider replacing a new connector.
-
2. How to remove the circular plastic terminal head
1. Use scissors or flat-nosed pliers to cut off or remove the outer shell on the circular plastic terminal head to expose the internal wiring part.
2. Use a screwdriver to loosen the screws on the terminal head to remove the terminal head.
3. Gently pull the terminal head by hand to remove it from the wire.
4. If the terminal head is very tight, you can use flat-nosed pliers or pliers to increase the removal force.
5. If you need to replace a new terminal head, you can insert the new terminal head into the wire and tighten the screws to ensure that the wiring is firm. -
3. How to remove a circular electrical connector
1. Loosen the locking ring. To remove a circular electrical connector, you first need to loosen the locking ring;
2. Remove the sealant. There is a sealant on the connector, which needs to be removed first.
3. Remove the terminal. First, loosen the terminal fastening or open the slot, and then carefully separate the plug and the socket; -
4. How many types of connectors are there?
1. Circular connector,
2. RF connector,
3. Rectangular connector:
4. SMB connector:
5. BNC connector;
