75-194128-6S vs TV07RQK-17-52P
| Part Number |
|
|
| Category | Circular Connectors | Circular Connectors |
| Manufacturer | Amphenol Industrial Operations | Amphenol Aerospace Operations |
| Description | CONN PLUG W/SOCKETS | CONN RCPT MALE 2POS GOLD CRIMP |
| Package | - | - |
| Series | MIL-DTL-22992, QWLD | MIL-DTL-38999 Series III, Tri-Start? TV |
| Mounting Type | Free Hanging (In-Line) | Panel Mount, Bulkhead - Front Side Nut |
| Termination | Crimp | Crimp |
| Ingress Protection | Waterproof | Environment Resistant |
| Voltage - Rated | 900VAC, 1250VDC | - |
| Contact Finish | Silver | Gold |
| Orientation | N (Normal) | N (Normal) |
| Number of Positions | 3 | 2 (Quadrax) |
| Connector Type | Receptacle, Female Sockets | Receptacle, Male Pins |
| Shell Size - Insert | 28-6 | 17-52 |
| Fastening Type | Threaded | Threaded |
| Shell Material, Finish | Aluminum, Anodic Coating (Alumilite) | Stainless Steel |
| Features | - | Firewall Usage, Shielded |
-
1. How to solder a circular connector
1. Remove the insulator, prepare the soldering iron and needle-nosed pliers or tweezers;
2. Place the blade of the soldering iron tip close to the solder joint, and keep the soldering iron at an angle of about 60° to the horizontal plane so that the molten tin can flow smoothly from the soldering iron tip to the solder joint. The time the soldering iron tip stays at the solder joint should be controlled to 1-2 seconds;
3. Make sure that the insulator is not burned, the tin on the solder joint is smooth, burr-free, and there is no cold solder joint, and the definition of the solder wire meets the requirements of the drawing. -
2. How to wire a circular connector
1. Insert the wire into the pin hole inside the connector to ensure that the metal conductor is in full contact with the pin.
2. Use wire twisters to tighten the screws or clips on the connector to ensure good and firm contact between the connector and the wire.
3. Check if there is any exposed metal surface on the connector. If necessary, re-strip it.
4. Wrap the connected wires with electrical tape to prevent loosening or short circuit problems. -
3. How to remove the circular plastic terminal head
1. Use scissors or flat-nosed pliers to cut off or remove the outer shell on the circular plastic terminal head to expose the internal wiring part.
2. Use a screwdriver to loosen the screws on the terminal head to remove the terminal head.
3. Gently pull the terminal head by hand to remove it from the wire.
4. If the terminal head is very tight, you can use flat-nosed pliers or pliers to increase the removal force.
5. If you need to replace a new terminal head, you can insert the new terminal head into the wire and tighten the screws to ensure that the wiring is firm. -
4. What are the materials of circular connectors?
1. Metal: It has good mechanical properties and conductivity, and is used for contacts and housings.
2. Plastic: Lightweight, good insulation, and able to resist corrosion by some chemicals, used for insulators and housings.
3. Rubber: Has good elasticity and corrosion resistance, used for waterproofing and sealing.
