PLB4G420005 vs W3M
| Part Number |
|
|
| Category | Circular Connectors | Circular Connectors |
| Manufacturer | ITT Cannon, LLC | Switchcraft Inc. |
| Description | CONN RCPT FMALE 5POS GOLD SLDR | CONN RCPT 3PIN MALE R/A PANEL MT |
| Package | - | - |
| Series | PL | Q-G? W |
| Mounting Type | Panel Mount, Bulkhead - Rear Side Nut | Panel Mount, Right Angle |
| Termination | Solder Cup | Solder |
| Ingress Protection | IP50 - Dust Protected | - |
| Current Rating | 7A | - |
| Contact Finish | Gold | - |
| Orientation | 0° | Keyed |
| Number of Positions | 5 | 3 |
| Connector Type | Receptacle, Female Sockets | Receptacle, Male Pins |
| Fastening Type | Latch Lock, Push-Pull | Push-Pull |
| Shell Material, Finish | Polysulfone (PSU) | Zinc Die Cast, Nickel Plated |
| Features | - | Mounting Hardware |
-
1. How to get pins out of circular connector
Use professional tools: For some connectors, professional tools may be required to safely remove pins. For example, the small two-petal needle remover mentioned may not be very easy to use, but if there is no other better method, you can try to use it. If the connector is damaged or the repair cost is too high, consider replacing a new connector.
-
2. How to solder a circular connector
1. Remove the insulator, prepare the soldering iron and needle-nosed pliers or tweezers;
2. Place the blade of the soldering iron tip close to the solder joint, and keep the soldering iron at an angle of about 60° to the horizontal plane so that the molten tin can flow smoothly from the soldering iron tip to the solder joint. The time the soldering iron tip stays at the solder joint should be controlled to 1-2 seconds;
3. Make sure that the insulator is not burned, the tin on the solder joint is smooth, burr-free, and there is no cold solder joint, and the definition of the solder wire meets the requirements of the drawing. -
3. What is a circular connector
A circular connector is a cylindrical electronic connector with a circular mating surface. It belongs to the fifth category of the interconnection classification and is mainly used for interconnection between devices. The design of circular connectors includes many types, such as low-frequency circular connectors, RF coaxial connectors and audio connectors, etc., with a wide operating temperature range from -55℃ to +150℃.
-
4. How to remove a circular electrical connector
1. Loosen the locking ring. To remove a circular electrical connector, you first need to loosen the locking ring;
2. Remove the sealant. There is a sealant on the connector, which needs to be removed first.
3. Remove the terminal. First, loosen the terminal fastening or open the slot, and then carefully separate the plug and the socket;
