RPC1-12P-6S(71) vs 17291-3PG-3ES
| Part Number |
|
|
| Category | Circular Connectors | Circular Connectors |
| Manufacturer | Hirose Electric Co Ltd | Conxall/Switchcraft |
| Description | CONN PLUG 6POS INLINE SKT | CONN RCPT 3POS PNL MNT PIN |
| Package | - | - |
| Series | RP | Micro-Con-X? |
| Mounting Type | Free Hanging (In-Line) | Panel Mount, Bulkhead - Front Side Nut |
| Termination | Solder Tabs | Solder |
| Current Rating | 5A | 7.5A |
| Contact Finish | Silver | Gold |
| Orientation | Keyed | Keyed |
| Number of Positions | 6 | 3 |
| Connector Type | Plug, Female Sockets | Receptacle, Male Pins |
| Shell Size - Insert | 12 | - |
| Fastening Type | Push-Pull | Bayonet Lock |
| Shell Material, Finish | Polyamide Resin and Polyacetal Resin | Thermoplastic |
| Ingress Protection | - | IP67 - Dust Tight, Waterproof |
| Voltage - Rated | - | 600VAC/DC |
-
1. How to solder a circular connector
1. Remove the insulator, prepare the soldering iron and needle-nosed pliers or tweezers;
2. Place the blade of the soldering iron tip close to the solder joint, and keep the soldering iron at an angle of about 60° to the horizontal plane so that the molten tin can flow smoothly from the soldering iron tip to the solder joint. The time the soldering iron tip stays at the solder joint should be controlled to 1-2 seconds;
3. Make sure that the insulator is not burned, the tin on the solder joint is smooth, burr-free, and there is no cold solder joint, and the definition of the solder wire meets the requirements of the drawing. -
2. How to wire a circular connector
1. Insert the wire into the pin hole inside the connector to ensure that the metal conductor is in full contact with the pin.
2. Use wire twisters to tighten the screws or clips on the connector to ensure good and firm contact between the connector and the wire.
3. Check if there is any exposed metal surface on the connector. If necessary, re-strip it.
4. Wrap the connected wires with electrical tape to prevent loosening or short circuit problems. -
3. How to remove a circular electrical connector
1. Loosen the locking ring. To remove a circular electrical connector, you first need to loosen the locking ring;
2. Remove the sealant. There is a sealant on the connector, which needs to be removed first.
3. Remove the terminal. First, loosen the terminal fastening or open the slot, and then carefully separate the plug and the socket; -
4. How many types of connectors are there?
1. Circular connector,
2. RF connector,
3. Rectangular connector:
4. SMB connector:
5. BNC connector;
