T4110001041-000 vs T4112001031-000
| Part Number |
|
|
| Category | Circular Connectors | Circular Connectors |
| Manufacturer | TE Connectivity AMP Connectors | TE Connectivity AMP Connectors |
| Description | CONN RCPT FMALE 4POS SCREW GOLD | CONN RCPT FMALE 3POS SCREW GOLD |
| Package | - | - |
| Series | M12 | M12 |
| Features | Backshell, Coupling Nut | Backshell, Coupling Nut |
| Mounting Type | Free Hanging (In-Line) | Free Hanging (In-Line), Right Angle |
| Termination | Screw | Screw |
| Ingress Protection | IP67 - Dust Tight, Waterproof | IP67 - Dust Tight, Waterproof |
| Current Rating | 4A | 4A |
| Voltage - Rated | 250V | 250V |
| Contact Finish | Gold | Gold |
| Orientation | A | A |
| Number of Positions | 4 | 3 |
| Connector Type | Receptacle, Female Sockets | Receptacle, Female Sockets |
| Shell Size - Insert | M12-4 | M12-3 |
| Fastening Type | Threaded | Threaded |
| Shell Material, Finish | Brass | Brass |
-
1. How to solder a circular connector
1. Remove the insulator, prepare the soldering iron and needle-nosed pliers or tweezers;
2. Place the blade of the soldering iron tip close to the solder joint, and keep the soldering iron at an angle of about 60° to the horizontal plane so that the molten tin can flow smoothly from the soldering iron tip to the solder joint. The time the soldering iron tip stays at the solder joint should be controlled to 1-2 seconds;
3. Make sure that the insulator is not burned, the tin on the solder joint is smooth, burr-free, and there is no cold solder joint, and the definition of the solder wire meets the requirements of the drawing. -
2. How to wire a circular connector
1. Insert the wire into the pin hole inside the connector to ensure that the metal conductor is in full contact with the pin.
2. Use wire twisters to tighten the screws or clips on the connector to ensure good and firm contact between the connector and the wire.
3. Check if there is any exposed metal surface on the connector. If necessary, re-strip it.
4. Wrap the connected wires with electrical tape to prevent loosening or short circuit problems. -
3. What are circular connectors used for
Circular connectors are mainly used for power connection, signal transmission, mechanical connection, etc. It is a multifunctional electronic connector widely used in various electronic devices and application scenarios.
-
4. What are the materials of circular connectors?
1. Metal: It has good mechanical properties and conductivity, and is used for contacts and housings.
2. Plastic: Lightweight, good insulation, and able to resist corrosion by some chemicals, used for insulators and housings.
3. Rubber: Has good elasticity and corrosion resistance, used for waterproofing and sealing.
