TVP00RS-17-73SA-S3 vs CTVP00RF-21-121PA-P2AD
| Part Number |
|
|
| Category | Circular Connectors | Circular Connectors |
| Manufacturer | Amphenol Aerospace Operations | Amphenol Aerospace Operations |
| Description | CONN RCPT FMALE 73POS GOLD SLDR | CONN RCPT MALE 121POS GOLD SLDR |
| Package | - | - |
| Series | MIL-DTL-38999 Series III, Tri-Start? HD | MIL-DTL-38999 Series III, Tri-Start? HD |
| Features | Shielded | Alignment Disc, Shielded |
| Mounting Type | Panel Mount, Flange; Through Hole | Panel Mount, Flange; Through Hole |
| Termination | Solder | Solder |
| Contact Finish | Gold | Gold |
| Orientation | A | A |
| Number of Positions | 73 | 121 |
| Connector Type | Receptacle, Female Sockets | Receptacle, Male Pins |
| Shell Size - Insert | 17-73 | 21-121 |
| Fastening Type | Threaded | Threaded |
| Shell Material, Finish | Stainless Steel, Nickel Plated | Composite, Nickel Plated, Electroless |
| Ingress Protection | - | Environment Resistant |
-
1. How to solder a circular connector
1. Remove the insulator, prepare the soldering iron and needle-nosed pliers or tweezers;
2. Place the blade of the soldering iron tip close to the solder joint, and keep the soldering iron at an angle of about 60° to the horizontal plane so that the molten tin can flow smoothly from the soldering iron tip to the solder joint. The time the soldering iron tip stays at the solder joint should be controlled to 1-2 seconds;
3. Make sure that the insulator is not burned, the tin on the solder joint is smooth, burr-free, and there is no cold solder joint, and the definition of the solder wire meets the requirements of the drawing. -
2. What does s mean in circular connectors sealcon
S-Video, the full name of Separate Video, is also known as SUPER VIDEO. It is a video signal transmission standard used to separate the brightness and color of the video signal to avoid mutual interference between brightness and color when the mixed video signal is output.
-
3. How to remove the circular plastic terminal head
1. Use scissors or flat-nosed pliers to cut off or remove the outer shell on the circular plastic terminal head to expose the internal wiring part.
2. Use a screwdriver to loosen the screws on the terminal head to remove the terminal head.
3. Gently pull the terminal head by hand to remove it from the wire.
4. If the terminal head is very tight, you can use flat-nosed pliers or pliers to increase the removal force.
5. If you need to replace a new terminal head, you can insert the new terminal head into the wire and tighten the screws to ensure that the wiring is firm. -
4. What are the materials of circular connectors?
1. Metal: It has good mechanical properties and conductivity, and is used for contacts and housings.
2. Plastic: Lightweight, good insulation, and able to resist corrosion by some chemicals, used for insulators and housings.
3. Rubber: Has good elasticity and corrosion resistance, used for waterproofing and sealing.
