AIB0UBSB7-40-53SC vs CTV07RF-19-88PB-P35AD
| Part Number |
|
|
| Category | Circular Connectors | Circular Connectors |
| Manufacturer | Amphenol Industrial Operations | Amphenol Aerospace Operations |
| Description | GT 60C 60#16 SKT RECP WALL | CONN RCPT MALE 88POS GOLD SLDR |
| Package | - | - |
| Series | * | MIL-DTL-38999 Series III, Tri-Start? HD |
| Features | - | Alignment Disc, Shielded |
| Mounting Type | - | Panel Mount, Bulkhead - Front Side Nut; Through Hole |
| Termination | - | Solder |
| Ingress Protection | - | Environment Resistant |
| Contact Finish | - | Gold |
| Orientation | - | B |
| Number of Positions | - | 88 |
| Connector Type | - | Receptacle, Male Pins |
| Shell Size - Insert | - | 19-88 |
| Fastening Type | - | Threaded |
| Shell Material, Finish | - | Composite, Nickel Plated, Electroless |
-
1. How to get pins out of circular connector
Use professional tools: For some connectors, professional tools may be required to safely remove pins. For example, the small two-petal needle remover mentioned may not be very easy to use, but if there is no other better method, you can try to use it. If the connector is damaged or the repair cost is too high, consider replacing a new connector.
-
2. How to solder a circular connector
1. Remove the insulator, prepare the soldering iron and needle-nosed pliers or tweezers;
2. Place the blade of the soldering iron tip close to the solder joint, and keep the soldering iron at an angle of about 60° to the horizontal plane so that the molten tin can flow smoothly from the soldering iron tip to the solder joint. The time the soldering iron tip stays at the solder joint should be controlled to 1-2 seconds;
3. Make sure that the insulator is not burned, the tin on the solder joint is smooth, burr-free, and there is no cold solder joint, and the definition of the solder wire meets the requirements of the drawing. -
3. How to wire a circular connector
1. Insert the wire into the pin hole inside the connector to ensure that the metal conductor is in full contact with the pin.
2. Use wire twisters to tighten the screws or clips on the connector to ensure good and firm contact between the connector and the wire.
3. Check if there is any exposed metal surface on the connector. If necessary, re-strip it.
4. Wrap the connected wires with electrical tape to prevent loosening or short circuit problems. -
4. What is the definition of a connector?
Connector, that is, CONNECTOR. It is also called connector, plug and socket in China. Generally refers to an electrical connector. That is, a device that connects two active devices to transmit current or signals. Connectors are a component that our electronic engineering technicians often come into contact with.
