AIB30-40-56PH vs MS27474T24F2S
| Part Number |
|
|
| Category | Circular Connectors | Circular Connectors |
| Manufacturer | Amphenol Industrial Operations | Amphenol Aerospace Operations |
| Description | GT 85C 85#16 PIN RECP WALL RM | CONN RCPT 100POS JAM NUT W/SCKT |
| Package | - | - |
| Series | * | Military, MIL-DTL-38999 Series II |
| Mounting Type | - | Panel Mount, Bulkhead - Front Side Nut |
| Termination | - | Crimp |
| Ingress Protection | - | Environment Resistant |
| Current Rating | - | 5A |
| Voltage - Rated | - | 400VAC, 500VDC |
| Contact Finish | - | Gold |
| Orientation | - | N (Normal) |
| Number of Positions | - | 100 |
| Connector Type | - | Receptacle, Female Sockets |
| Shell Size - Insert | - | 24-2 |
| Fastening Type | - | Bayonet Lock |
| Shell Material, Finish | - | Aluminum, Nickel Plated, Electroless |
-
1. How to get pins out of circular connector
Use professional tools: For some connectors, professional tools may be required to safely remove pins. For example, the small two-petal needle remover mentioned may not be very easy to use, but if there is no other better method, you can try to use it. If the connector is damaged or the repair cost is too high, consider replacing a new connector.
-
2. How to solder a circular connector
1. Remove the insulator, prepare the soldering iron and needle-nosed pliers or tweezers;
2. Place the blade of the soldering iron tip close to the solder joint, and keep the soldering iron at an angle of about 60° to the horizontal plane so that the molten tin can flow smoothly from the soldering iron tip to the solder joint. The time the soldering iron tip stays at the solder joint should be controlled to 1-2 seconds;
3. Make sure that the insulator is not burned, the tin on the solder joint is smooth, burr-free, and there is no cold solder joint, and the definition of the solder wire meets the requirements of the drawing. -
3. How to wire a circular connector
1. Insert the wire into the pin hole inside the connector to ensure that the metal conductor is in full contact with the pin.
2. Use wire twisters to tighten the screws or clips on the connector to ensure good and firm contact between the connector and the wire.
3. Check if there is any exposed metal surface on the connector. If necessary, re-strip it.
4. Wrap the connected wires with electrical tape to prevent loosening or short circuit problems. -
4. How to remove the circular plastic terminal head
1. Use scissors or flat-nosed pliers to cut off or remove the outer shell on the circular plastic terminal head to expose the internal wiring part.
2. Use a screwdriver to loosen the screws on the terminal head to remove the terminal head.
3. Gently pull the terminal head by hand to remove it from the wire.
4. If the terminal head is very tight, you can use flat-nosed pliers or pliers to increase the removal force.
5. If you need to replace a new terminal head, you can insert the new terminal head into the wire and tighten the screws to ensure that the wiring is firm.
