CIR00R-28-21S-F80 vs CIR06F-16S-5S-F80
| Part Number |
|
|
| Category | Circular Connectors | Circular Connectors |
| Manufacturer | ITT Cannon, LLC | ITT Cannon, LLC |
| Description | CONN RCPT 37POS PNL MNT SKT | CONN PLUG 3POS STRGHT SKT |
| Package | - | - |
| Series | MIL-DTL-5015, CIR | MIL-DTL-5015, CIR |
| Mounting Type | Panel Mount, Flange | Free Hanging (In-Line) |
| Termination | Crimp | Crimp |
| Ingress Protection | Environment Proof | Environment Proof |
| Current Rating | 13A | 13A |
| Voltage - Rated | 500VAC, 700VDC | 500VAC, 700VDC |
| Contact Finish | Silver | Silver |
| Orientation | N (Normal) | N (Normal) |
| Number of Positions | 37 | 3 |
| Connector Type | Receptacle, Female Sockets | Plug, Female Sockets |
| Shell Size - Insert | 28-21 | 16S-5 |
| Fastening Type | Bayonet Lock | Bayonet Lock |
| Shell Material, Finish | Aluminum Alloy, Olive Drab Cadmium Plated | Aluminum Alloy, Olive Drab Cadmium Plated |
| Features | - | Cable Clamp |
-
1. How to get pins out of circular connector
Use professional tools: For some connectors, professional tools may be required to safely remove pins. For example, the small two-petal needle remover mentioned may not be very easy to use, but if there is no other better method, you can try to use it. If the connector is damaged or the repair cost is too high, consider replacing a new connector.
-
2. How to wire a circular connector
1. Insert the wire into the pin hole inside the connector to ensure that the metal conductor is in full contact with the pin.
2. Use wire twisters to tighten the screws or clips on the connector to ensure good and firm contact between the connector and the wire.
3. Check if there is any exposed metal surface on the connector. If necessary, re-strip it.
4. Wrap the connected wires with electrical tape to prevent loosening or short circuit problems. -
3. How to remove the circular plastic terminal head
1. Use scissors or flat-nosed pliers to cut off or remove the outer shell on the circular plastic terminal head to expose the internal wiring part.
2. Use a screwdriver to loosen the screws on the terminal head to remove the terminal head.
3. Gently pull the terminal head by hand to remove it from the wire.
4. If the terminal head is very tight, you can use flat-nosed pliers or pliers to increase the removal force.
5. If you need to replace a new terminal head, you can insert the new terminal head into the wire and tighten the screws to ensure that the wiring is firm. -
4. What is the definition of a connector?
Connector, that is, CONNECTOR. It is also called connector, plug and socket in China. Generally refers to an electrical connector. That is, a device that connects two active devices to transmit current or signals. Connectors are a component that our electronic engineering technicians often come into contact with.
