CIR06F-16S-5S-F80 vs CIR06R-36-7S-F80
| Part Number |
|
|
| Category | Circular Connectors | Circular Connectors |
| Manufacturer | ITT Cannon, LLC | ITT Cannon, LLC |
| Description | CONN PLUG 3POS STRGHT SKT | CONN PLUG 47POS STRGHT SKT |
| Package | - | - |
| Series | MIL-DTL-5015, CIR | MIL-DTL-5015, CIR |
| Features | Cable Clamp | - |
| Mounting Type | Free Hanging (In-Line) | Free Hanging (In-Line) |
| Termination | Crimp | Crimp |
| Ingress Protection | Environment Proof | Environment Proof |
| Current Rating | 13A | 13A, 23A |
| Voltage - Rated | 500VAC, 700VDC | 500VAC, 700VDC |
| Contact Finish | Silver | Silver |
| Orientation | N (Normal) | N (Normal) |
| Number of Positions | 3 | 47 |
| Connector Type | Plug, Female Sockets | Plug, Female Sockets |
| Shell Size - Insert | 16S-5 | 36-7 |
| Fastening Type | Bayonet Lock | Bayonet Lock |
| Shell Material, Finish | Aluminum Alloy, Olive Drab Cadmium Plated | Aluminum Alloy, Olive Drab Cadmium Plated |
-
1. How to solder a circular connector
1. Remove the insulator, prepare the soldering iron and needle-nosed pliers or tweezers;
2. Place the blade of the soldering iron tip close to the solder joint, and keep the soldering iron at an angle of about 60° to the horizontal plane so that the molten tin can flow smoothly from the soldering iron tip to the solder joint. The time the soldering iron tip stays at the solder joint should be controlled to 1-2 seconds;
3. Make sure that the insulator is not burned, the tin on the solder joint is smooth, burr-free, and there is no cold solder joint, and the definition of the solder wire meets the requirements of the drawing. -
2. How to wire a circular connector
1. Insert the wire into the pin hole inside the connector to ensure that the metal conductor is in full contact with the pin.
2. Use wire twisters to tighten the screws or clips on the connector to ensure good and firm contact between the connector and the wire.
3. Check if there is any exposed metal surface on the connector. If necessary, re-strip it.
4. Wrap the connected wires with electrical tape to prevent loosening or short circuit problems. -
3. What are circular connectors used for
Circular connectors are mainly used for power connection, signal transmission, mechanical connection, etc. It is a multifunctional electronic connector widely used in various electronic devices and application scenarios.
-
4. How to remove a circular electrical connector
1. Loosen the locking ring. To remove a circular electrical connector, you first need to loosen the locking ring;
2. Remove the sealant. There is a sealant on the connector, which needs to be removed first.
3. Remove the terminal. First, loosen the terminal fastening or open the slot, and then carefully separate the plug and the socket;
