CIR08F-20-29S-F80 vs CIR06F-16S-5P
| Part Number |
|
|
| Category | Circular Connectors | Circular Connectors |
| Manufacturer | ITT Cannon, LLC | ITT Cannon, LLC |
| Description | CONN PLUG 17POS INLINE RA SKT | CONN PLUG 3POS STRGHT PIN |
| Package | - | - |
| Series | MIL-DTL-5015, CIR | MIL-DTL-5015, CIR |
| Features | Cable Clamp | Cable Clamp |
| Mounting Type | Free Hanging (In-Line), Right Angle | Free Hanging (In-Line) |
| Termination | Crimp | Solder Cup |
| Ingress Protection | Environment Proof | Environment Proof |
| Current Rating | 13A | 13A |
| Voltage - Rated | 500VAC, 700VDC | 500VAC, 700VDC |
| Contact Finish | Silver | Silver |
| Orientation | N (Normal) | N (Normal) |
| Number of Positions | 17 | 3 |
| Connector Type | Plug, Female Sockets | Plug, Male Pins |
| Shell Size - Insert | 20-29 | 16S-5 |
| Fastening Type | Bayonet Lock | Bayonet Lock |
| Shell Material, Finish | Aluminum Alloy, Olive Drab Cadmium Plated | Aluminum Alloy, Olive Drab Cadmium Plated |
-
1. How to get pins out of circular connector
Use professional tools: For some connectors, professional tools may be required to safely remove pins. For example, the small two-petal needle remover mentioned may not be very easy to use, but if there is no other better method, you can try to use it. If the connector is damaged or the repair cost is too high, consider replacing a new connector.
-
2. How to solder a circular connector
1. Remove the insulator, prepare the soldering iron and needle-nosed pliers or tweezers;
2. Place the blade of the soldering iron tip close to the solder joint, and keep the soldering iron at an angle of about 60° to the horizontal plane so that the molten tin can flow smoothly from the soldering iron tip to the solder joint. The time the soldering iron tip stays at the solder joint should be controlled to 1-2 seconds;
3. Make sure that the insulator is not burned, the tin on the solder joint is smooth, burr-free, and there is no cold solder joint, and the definition of the solder wire meets the requirements of the drawing. -
3. How to wire a circular connector
1. Insert the wire into the pin hole inside the connector to ensure that the metal conductor is in full contact with the pin.
2. Use wire twisters to tighten the screws or clips on the connector to ensure good and firm contact between the connector and the wire.
3. Check if there is any exposed metal surface on the connector. If necessary, re-strip it.
4. Wrap the connected wires with electrical tape to prevent loosening or short circuit problems. -
4. What is the difference between circular and rectangular connectors?
The most essential difference is the shape difference, followed by the difference between parameters, such as voltage, working scene, current, etc. What is the difference between circular connectors and rectangular connectors in terms of appearance, size, structure, color, and function? In terms of appearance, the circular connector is a perfect circle, and the rectangular connector is square. The size can be designed the same.
The structure is a circular track and a square track, and the colors are all industrial electroplating colors.
