GTS08F40-56P vs SP07CP-16-8P
| Part Number |
|
|
| Category | Circular Connectors | Circular Connectors |
| Manufacturer | Amphenol Industrial Operations | Amphenol Industrial Operations |
| Description | GT 85C 85#16 PIN PLUG | CONN RCPT 8POS JAM NUT PIN |
| Package | - | - |
| Series | * | MIL-DTL-26482 Series I, SP |
| Features | - | Potted |
| Mounting Type | - | Panel Mount, Bulkhead - Front Side Nut |
| Termination | - | Crimp |
| Current Rating | - | 13A |
| Voltage - Rated | - | 1000VAC |
| Contact Finish | - | Gold |
| Orientation | - | N (Normal) |
| Number of Positions | - | 8 |
| Connector Type | - | Receptacle, Male Pins |
| Shell Size - Insert | - | 16-8 |
| Fastening Type | - | Bayonet Lock |
| Shell Material, Finish | - | Aluminum, Anodic Coating (Alumilite) |
-
1. How to cnlinko 4 pin power industrial circular connector
1. Confirm the voltage, current and frequency:
2. Choose the right environment: In normal environment, regular plugs and sockets can be used. IP67 anti-immersion plugs and sockets are used in harsh environment.
3. Pay attention to the installation of the connector: Make sure that the socket used to install the connector on the power supply line has a cover to prevent electric shock.
4. Check the connector status: Before use, check whether the model, code, number, plug position and direction of the connector meet the requirements of the design and process documents. 5. Correct plugging and unplugging operation: Before plugging, check whether the code, interface, etc. of the plug to be plugged in correspond to the socket, and accurately position them. -
2. How to get pins out of circular connector
Use professional tools: For some connectors, professional tools may be required to safely remove pins. For example, the small two-petal needle remover mentioned may not be very easy to use, but if there is no other better method, you can try to use it. If the connector is damaged or the repair cost is too high, consider replacing a new connector.
-
3. How to solder a circular connector
1. Remove the insulator, prepare the soldering iron and needle-nosed pliers or tweezers;
2. Place the blade of the soldering iron tip close to the solder joint, and keep the soldering iron at an angle of about 60° to the horizontal plane so that the molten tin can flow smoothly from the soldering iron tip to the solder joint. The time the soldering iron tip stays at the solder joint should be controlled to 1-2 seconds;
3. Make sure that the insulator is not burned, the tin on the solder joint is smooth, burr-free, and there is no cold solder joint, and the definition of the solder wire meets the requirements of the drawing. -
4. How to remove the circular plastic terminal head
1. Use scissors or flat-nosed pliers to cut off or remove the outer shell on the circular plastic terminal head to expose the internal wiring part.
2. Use a screwdriver to loosen the screws on the terminal head to remove the terminal head.
3. Gently pull the terminal head by hand to remove it from the wire.
4. If the terminal head is very tight, you can use flat-nosed pliers or pliers to increase the removal force.
5. If you need to replace a new terminal head, you can insert the new terminal head into the wire and tighten the screws to ensure that the wiring is firm.
