MS17344R32N73P vs TVP00DZ-17-73SC-S3AD
| Part Number |
|
|
| Category | Circular Connectors | Circular Connectors |
| Manufacturer | Amphenol Aerospace Operations | Amphenol Aerospace Operations |
| Description | CONN PLUG 46POS STRAIGHT W/PINS | CONN RCPT FMALE 73POS GOLD SLDR |
| Package | - | - |
| Series | Military, MIL-DTL-22992 | MIL-DTL-38999 Series III, Tri-Start? HD |
| Mounting Type | Free Hanging (In-Line) | Panel Mount, Flange; Through Hole |
| Termination | Solder Cup | Solder |
| Ingress Protection | Waterproof | Environment Resistant |
| Voltage - Rated | 500VAC, 700VDC | - |
| Contact Finish | Silver | Gold |
| Orientation | N (Normal) | C |
| Number of Positions | 46 | 73 |
| Connector Type | Plug, Male Pins | Receptacle, Female Sockets |
| Shell Size - Insert | 32-73 | 17-73 |
| Fastening Type | Threaded | Threaded |
| Shell Material, Finish | Aluminum, Anodic Coating (Alumilite) | Aluminum, Black Zinc Nickel Plated |
| Features | - | Alignment Disc |
-
1. How to cnlinko 4 pin power industrial circular connector
1. Confirm the voltage, current and frequency:
2. Choose the right environment: In normal environment, regular plugs and sockets can be used. IP67 anti-immersion plugs and sockets are used in harsh environment.
3. Pay attention to the installation of the connector: Make sure that the socket used to install the connector on the power supply line has a cover to prevent electric shock.
4. Check the connector status: Before use, check whether the model, code, number, plug position and direction of the connector meet the requirements of the design and process documents. 5. Correct plugging and unplugging operation: Before plugging, check whether the code, interface, etc. of the plug to be plugged in correspond to the socket, and accurately position them. -
2. How to solder a circular connector
1. Remove the insulator, prepare the soldering iron and needle-nosed pliers or tweezers;
2. Place the blade of the soldering iron tip close to the solder joint, and keep the soldering iron at an angle of about 60° to the horizontal plane so that the molten tin can flow smoothly from the soldering iron tip to the solder joint. The time the soldering iron tip stays at the solder joint should be controlled to 1-2 seconds;
3. Make sure that the insulator is not burned, the tin on the solder joint is smooth, burr-free, and there is no cold solder joint, and the definition of the solder wire meets the requirements of the drawing. -
3. What are circular connectors used for
Circular connectors are mainly used for power connection, signal transmission, mechanical connection, etc. It is a multifunctional electronic connector widely used in various electronic devices and application scenarios.
-
4. How to remove the circular plastic terminal head
1. Use scissors or flat-nosed pliers to cut off or remove the outer shell on the circular plastic terminal head to expose the internal wiring part.
2. Use a screwdriver to loosen the screws on the terminal head to remove the terminal head.
3. Gently pull the terminal head by hand to remove it from the wire.
4. If the terminal head is very tight, you can use flat-nosed pliers or pliers to increase the removal force.
5. If you need to replace a new terminal head, you can insert the new terminal head into the wire and tighten the screws to ensure that the wiring is firm.
