OPA210IDBVT vs OPA4202ID
| Part Number |
|
|
| Category | Linear - Amplifiers - Instrumentation, OP Amps, Buffer Amps | Linear - Amplifiers - Instrumentation, OP Amps, Buffer Amps |
| Manufacturer | Texas Instruments | Texas Instruments |
| Description | SINGLE-CHANNEL HIGH-SPEED STANDA | IC OPAMP GP 4 CIRCUIT 14SOIC |
| Package | Tube | Tube |
| Series | - | - |
| Operating Temperature | -40°C ~ 125°C (TA) | -40°C ~ 105°C (TA) |
| Mounting Type | Surface Mount | Surface Mount |
| Package / Case | SC-74A, SOT-753 | 14-SOIC (0.154\", 3.90mm Width) |
| Supplier Device Package | SOT-23-5 | 14-SOIC |
| Current - Supply | 2.2mA | 580µA (x4 Channels) |
| Output Type | Push-Pull, Rail-to-Rail | - |
| Number of Circuits | 2 | 4 |
| Voltage - Supply, Single/Dual (±) | 4.5V ~ 36V, ±2.25V ~ 18V | 4.5V ~ 36V, ±2.25V ~ 18V |
| Current - Output / Channel | - | 35 mA |
| -3db Bandwidth | - | - |
| Amplifier Type | General Purpose | General Purpose |
| Current - Input Bias | 300 pA | 250 pA |
| Voltage - Input Offset | 5 µV | 20 µV |
| Slew Rate | 6.4V/µs | 0.35V/µs |
| Gain Bandwidth Product | 18 MHz | 1 MHz |
-
1. What is an instrumentation amplifier and what is it mainly used for?
An instrumentation amplifier is a high-precision amplifier designed to amplify low-level differential signals with high input impedance and high common mode rejection ratio (CMRR), and is commonly used in scenarios such as medical equipment, sensor signal processing, and industrial measurements.
-
2. What is a gain adjustable instrumentation amplifier?
Gain-adjustable instrumentation amplifiers allow the gain to be adjusted by external resistors or digital controls to accommodate the dynamic range of different signal sources. These amplifiers are commonly used in a variety of sensor systems.
-
3. What is Slew Rate and how does it affect op amp performance?
Slew rate is the maximum rate of change of an operational amplifier's output voltage over time. Higher slew rates are good for fast-changing signals and can handle higher frequency inputs, while lower slew rates can cause signal distortion.
-
4. How are operational amplifiers used in filter circuits?
Operational amplifiers can be used to build a variety of active filter circuits, including low-pass, high-pass, band-pass, and band-reject filters, which are commonly used for noise removal and signal conditioning in signal processing.
