QS3VH16244PAG8 vs SN74CBTS16211DL
| Part Number |
|
|
| Category | Logic - Signal Switches, Multiplexers, Decoders | Logic - Signal Switches, Multiplexers, Decoders |
| Manufacturer | Renesas Electronics America Inc | Texas Instruments |
| Description | IC BUS SWITCH 4 X 1:1 48TSSOP | IC BUS SWITCH 12 X 1:1 56SSOP |
| Package | Cut Tape (CT) | Tube |
| Series | 3VH | 74CBTS |
| Type | Bus Switch | Bus Switch |
| Voltage - Supply | 2.3V ~ 3.6V | 4.5V ~ 5.5V |
| Operating Temperature | -40°C ~ 85°C | -40°C ~ 85°C |
| Mounting Type | Surface Mount | Surface Mount |
| Package / Case | 48-TFSOP (0.240\", 6.10mm Width) | 56-BSSOP (0.295\", 7.50mm Width) |
| Supplier Device Package | 48-TSSOP | 56-SSOP |
| Voltage Supply Source | Single Supply | Single Supply |
| Circuit | 4 x 1:1 | 12 x 1:1 |
| Current - Output High, Low | - | - |
| Independent Circuits | 4 | 2 |
-
1. What is a signal switch?
A signal switch is an electronic component that controls the path of a signal. It can be mechanical (such as a toggle switch, button, etc.) or electronic (such as a transistor, field effect tube, etc.). The main function of a signal switch is to switch the signal path between different circuits, or to turn on/off a specific signal line.
-
2. What are the four types of switches?
Single-pole single-throw (SPST) - The most basic switch, with only one input and one output, can be turned on or off.
Single-pole double-throw (SPDT) - There is a common terminal, a normally closed terminal, and a normally open terminal, which can be used to select one of two different paths.
Double-pole single-throw (DPST) - There are two independent single-pole single-throw switches, which operate in conjunction and can control two lines at the same time.
Double Pole Double Throw (DPDT) - There are two independent sets of single pole double throw switches, each with its own common, normally closed and normally open terminals, which can control two lines at the same time, and each line has two state selections. -
3. What is the difference between a decoder and a multiplexer?
The difference between a decoder and a multiplexer is that they have opposite functions. A decoder converts encoded data into the corresponding original information or performs a specific operation; while a multiplexer combines multiple signal sources into a single signal stream.
-
4. What are some examples of decoders?
BCD to 7-segment decoder
Binary to Octal Decoder
Address Decoder in memory systems
