W6A82-8SG-528 vs 8P1P00217NGL421
| Part Number |
|
|
| Category | Circular Connectors | Circular Connectors |
| Manufacturer | Conxall/Switchcraft | NorComp Inc. |
| Description | CONN PLUG FMALE 8POS GOLD SLDR | CONN PLUG MALE 2POS GOLD SOLDER |
| Package | - | - |
| Series | Mini-Con-X? | QUIK-LOQ? 8P1P |
| Features | Backshell, Coupling Nut, UV Resistant | Backshell |
| Mounting Type | Free Hanging (In-Line) | Free Hanging (In-Line) |
| Termination | Solder Cup | Solder Cup |
| Ingress Protection | IP67 - Dust Tight, Waterproof | IP50 - Dust Protected |
| Current Rating | 2A, 10A | 10A |
| Voltage - Rated | 250V | 500V |
| Contact Finish | Gold | Gold |
| Orientation | Keyed | Keyed |
| Number of Positions | 8 (6 + 2 Power) | 2 |
| Connector Type | Plug, Female Sockets | Plug, Male Pins |
| Fastening Type | Bayonet Lock | Push-Pull |
| Shell Material, Finish | Thermoplastic | Polyacrylonitrile Butadiene Styrene (ABS), Polycarbonate (PC) |
-
1. How to cnlinko 4 pin power industrial circular connector
1. Confirm the voltage, current and frequency:
2. Choose the right environment: In normal environment, regular plugs and sockets can be used. IP67 anti-immersion plugs and sockets are used in harsh environment.
3. Pay attention to the installation of the connector: Make sure that the socket used to install the connector on the power supply line has a cover to prevent electric shock.
4. Check the connector status: Before use, check whether the model, code, number, plug position and direction of the connector meet the requirements of the design and process documents. 5. Correct plugging and unplugging operation: Before plugging, check whether the code, interface, etc. of the plug to be plugged in correspond to the socket, and accurately position them. -
2. How to solder a circular connector
1. Remove the insulator, prepare the soldering iron and needle-nosed pliers or tweezers;
2. Place the blade of the soldering iron tip close to the solder joint, and keep the soldering iron at an angle of about 60° to the horizontal plane so that the molten tin can flow smoothly from the soldering iron tip to the solder joint. The time the soldering iron tip stays at the solder joint should be controlled to 1-2 seconds;
3. Make sure that the insulator is not burned, the tin on the solder joint is smooth, burr-free, and there is no cold solder joint, and the definition of the solder wire meets the requirements of the drawing. -
3. How to remove a circular electrical connector
1. Loosen the locking ring. To remove a circular electrical connector, you first need to loosen the locking ring;
2. Remove the sealant. There is a sealant on the connector, which needs to be removed first.
3. Remove the terminal. First, loosen the terminal fastening or open the slot, and then carefully separate the plug and the socket; -
4. What is the definition of a connector?
Connector, that is, CONNECTOR. It is also called connector, plug and socket in China. Generally refers to an electrical connector. That is, a device that connects two active devices to transmit current or signals. Connectors are a component that our electronic engineering technicians often come into contact with.
